DF198 BMW Fault Code

Description:

BMW Mass Air Flow (MAF) Sensor Intermittent The MAF sensor circuit is monitored by the PCM for sudden voltage (or air flow) input change through the comprehensive component monitor (CCM).

If during the last 40 warm-up cycles in key ON engine running the PCM detects a voltage (or air flow) change beyond the minimum or maximum calibrated limit, a continuous memory diagnostic trouble code (DTC) is stored.

DF198 Code Symptoms :

The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. DF198 code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.

Diagnosis And Repairing DF198

DF198 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to fix DF198 code ?

• Failures of clutch motion/travel sensors.
• Exhaust tube
• EVAP canister or fuel tank leaks
• Starting system circuit Dead (Weak) battery

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source.

Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.